Udp-Jitter Test Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Square-Sum of round trip time: 4096
Last succeeded probe time: 2007-03-27 13:40:36.2
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0

1.12.5 UDP-jitter Test Configuration Example

I. Network requirements
Use the NQA UDP-jitter function to test the delay jitter of packet transmission between
Device A and Device B.
II. Network diagram
Figure 1-7 Network diagram for UDP-jitter test
III. Configuration procedure
1) Configure Device B.
# Enable the NQA server and configure the listening IP address as 10.2.2.2 and port
number as 9000.
<DeviceB> system-view
[DeviceB] nqa server enable
[DeviceB] nqa server udp-echo 10.2.2.2 9000
2) Configure Device A.
# Create a UDP-jitter test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type udp-jitter
[DeviceA-nqa-admin-test-udp-jitter] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-udp-jitter] destination port 9000
[DeviceA-nqa-admin-test-udp-jitter] quit
# Enable the UDP-jitter test.
1-27
Chapter 1 NQA Configuration