Rmon Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – SNMP-RMON
H3C S5500-EI Series Ethernet Switches
Display RMON prialarm
configuration information
Display RMON events
configuration information
Display RMON event log
information

2.4 RMON Configuration Example

I. Network requirements
Agent is connected to a configuration terminal through its console port and to a remote
NMS across the Internet.
Create an entry in the RMON Ethernet statistics table to gather statistics on
GigabitEthernet 1/0/1, and logging is enabled after received bytes exceed the specified
threshold.
II. Network diagram
Figure 2-1 Network diagram for RMON (on a switch)
III. Configuration procedure
# Configure RMON to gather statistics for interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet 1/0/1] rmon statistics 1 owner user1-rmon
[Sysname-GigabitEthernet 1/0/1] quit
# Display RMON statistics for interface GigabitEthernet 1/0/1.
<Sysname> display rmon statistics GigabitEthernet 1/0/1
Statistics entry 1 owned by user1-rmon is VALID.
Interface : GigabitEthernet1/0/1<ifIndex.1>
etherStatsOctets
etherStatsBroadcastPkts
To do...
: 0
: 0
Use the command...
display rmon prialarm
[ entry-number ]
display rmon event
[ entry-number ]
display rmon eventlog
[ event-number ]
, etherStatsPkts
, etherStatsMulticastPkts : 0
2-6
Chapter 2 RMON Configuration
Remarks
Available in
any view
Available in
any view
Available in
any view
: 0