H3C S5500-EI series Operation Manual page 1073

Operation Manual – QoS
H3C S5500-EI Series Ethernet Switches
To do...
Enter system view
Enter
port
view or
port
group
view
Configure WRR
queue scheduling
4.4.2 Configuration Examples
I. Network requirements
Configure WRR queue scheduling algorithm on GigabitEthernet1/0/1, and assign
weight 1, 2, 4, 6, 8, 10, 12, and 14 to queue 0 through queue 7.
II. Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure the WRR queues on GigabitEthernet1/0/1 port.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wrr 0 group 1 weight 1
[Sysname-GigabitEthernet1/0/1] qos wrr 1 group 1 weight 2
[Sysname-GigabitEthernet1/0/1] qos wrr 2 group 1 weight 4
[Sysname-GigabitEthernet1/0/1] qos wrr 3 group 1 weight 6
[Sysname-GigabitEthernet1/0/1] qos wrr 4 group 1 weight 8
[Sysname-GigabitEthernet1/0/1] qos wrr 5 group 1 weight 10
[Sysname-GigabitEthernet1/0/1] qos wrr 6 group 1 weight 12
[Sysname-GigabitEthernet1/0/1] qos wrr 7 group 1 weight 14
Use the command...
system-view
Enter
interface interface-type
port
interface-number
view
Enter
port-group { manual
port
port-group-name |
group
aggregation agg-id }
view
qos wrr queue-id group
group-id weight
schedule-value
Chapter 4 Congestion Management
4-5
Remarks
—
Perform either of the two
operations.
The configuration
performed in Ethernet port
view applies to the current
port only. The configuration
performed in port group
view applies to all the ports
in the port group
Required
By default, all the ports
adopt the WRR queue
scheduling algorithm, with
the weight values assigned
to queue 0 through queue 7
being 1, 2, 3, 4, 5, 9, 13,
and 15.