H3C S5500-EI series Operation Manual page 1228

Operation Manual – Information Center
H3C S5500-EI Series Ethernet Switches
Information
channel number
4
5
6
7
8
9
Note:
Configurations for the six output destinations function independently and take effect
only after the information center is enabled.
IV. Outputting system information by source module
The system is composed of a variety of protocol modules, board drivers, and
configuration modules. The system information can be classified, filtered, and output by
source module. Some source module names and descriptions are shown in
Table 1-3 Source module list
Module name
8021X
ACL
ARP
BGP
CFM
CLST
CMD
default
DEV
DHCP
Default channel
name
Log buffer (Receives log information, a
logbuffer buffer inside the router for recording
information.)
snmpagent SNMP NMS (Receives trap information)
Not specified (Receives log, trap, and
channel6
debugging information)
Not specified (Receives log, trap, and
channel7
debugging information)
Not specified (Receives log, trap, and
channel8
debugging information)
Not specified (Receives log, trap, and
channel9
debugging information)
802.1X module
Access Control List module
Address Resolution Protocol module
Border Gateway Protocol module
Configuration File Management module
Cluster Configuration module
Command line module
Default setting of all modules
Device management module
Dynamic Host Configuration Protocol module
1-3
Chapter 1 Information Center Configuration
Default output destination
Description
Table 1-3.