Configuring Cluster Member Management - H3C S5500-EI series Operation Manual

Operation Manual – Cluster Management
H3C S5500-EI Series Ethernet Switches
Configure the interval to
send MAC address
negotiation broadcast
packets for cluster
management multicast
packets

1.3.10 Configuring Cluster Member Management

I. Adding/Removing a member device
You can manually add a candidate device to a cluster, or remove a member device from
a cluster. These operations must be done through the management device, otherwise
you will be prompted with an error message.
Follow these steps to add/remove a member device:
Enter system view
Enter cluster view
Add a candidate device to
the cluster
Remove a member device
from the cluster
II. Rebooting a member device
Communication between the management and member devices may be interrupted
due to some configuration errors. Through the remote control function of member
devices, you can control them remotely on the management device. For example, you
can reboot a member device that operates improperly and specify to delete the booting
configuration file when the member device reboots, and thus achieve normal
communication between the management and member devices.
Follow these steps to reboot a member device:
Enter system view
Enter cluster view
To do...
cluster-mac syn-interval
interval-time
To do...
system-view
cluster
add-member
[ member-number ]
mac-address
mac-address [ password
password ]
delete-member
member-number
[ to-black-list ]
To do...
system-view
cluster
Chapter 1 Cluster Management Configuration
Use the command...
Use the command...
Use the command...
1-16
Remarks
Optional
One minute by default.
Remarks
—
—
Optional
Required
Remarks
—
—