H3C S5500-EI series Operation Manual page 1371

Hide thumbs Also See for S5500-EI series:

Table of Contents

Operation Manual – SSH

H3C S5500-EI Series Ethernet Switches

[Switch-ui-vty0-4] authentication-mode scheme

# Enable the user interface to support SSH.

[Switch-ui-vty0-4] protocol inbound ssh

[Switch-ui-vty0-4] quit

# Create local user client001, and set the user command privilege level to 3

[Switch] local-user client001

[Switch-luser-client001] password simple aabbcc

[Switch-luser-client001] service-type ssh level 3

[Switch-luser-client001] quit

# Specify the service type for user client001 as Stelnet, and the authentication

method as password.

[Switch] ssh user client001 service-type stelnet authentication-type password

Configure the SSH client

There are a variety of SSH client software, such as PuTTY, OpenSSH, and so on. The

following is an example of configuring SSH client using PuTT v0.58.

# Establish a connection with the SSH server

Launch PuTTY.exe to enter the following interface. In the Host Name (or IP address)

text box, enter the IP address of the server (192.168.1.40).

Chapter 1 SSH Configuration

Chapters

Table of Contents