Configuring The Collaboration Function - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Configure common
optional parameters

1.7 Configuring the Collaboration Function

Collaboration is implemented by establishing collaboration entries to monitor the
detection results of the current test group. If the number of consecutive probe failures
reaches the threshold, the configured action is triggered.
Follow these steps to configure the collaboration function:
Enter system view
Enter NQA test group
view
Enter test type view of the
test group
Create a Reaction entry
Exit to system view
Create a Track object and
associate it with the
specified Reaction entry
of the NQA test group
Caution:
You cannot modify the content of a reaction entry using the reaction command after
the collaboration object is created.
To do...
Refer to
Optional Parameters
Common to an NQA Test
Group
To do...
system-view
nqa entry admin-name
operation-tag
type { dhcp | dlsw | ftp |
http | icmp-echo | snmp |
tcp | udp-echo }
reaction item-num
checked-element
probe-fail
threshold-type
consecutive occurrences
[ action-type { none |
trigger-only } ]
quit
track entry-number nqa
entry admin-name
operation-tag reaction
item-num
Use the command...
Configuring
Use the command...
1-19
Chapter 1 NQA Configuration
Remarks
Optional
Remarks
—
—
The collaboration function
is not supported in
UDP-jitter tests.
Required
Not created by default.
—
Required
Not created by default.