H3C S5500-EI series Operation Manual page 830

Operation Manual – Multicast
H3C S5500-EI Series Ethernet Switches
2) Enable IP multicast routing, enable PIM-SM and IGMP, and configure a PIM-SM
domain border
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and
enable IGMP on the host-side interface VLAN-interface 200.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 103
[SwitchA-Vlan-interface103] pim sm
[SwitchA-Vlan-interface103] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] igmp enable
[SwitchA-Vlan-interface200] pim sm
[SwitchA-Vlan-interface200] quit
The configuration on Switch B, Switch C, Switch D, Switch E, and Switch F is similar to
the configuration on Switch A.
# Configure PIM domain borders on Switch B.
[SwitchB] interface vlan-interface 102
[SwitchB-Vlan-interface102] pim bsr-boundary
[SwitchB-Vlan-interface102] quit
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] pim bsr-boundary
[SwitchB-Vlan-interface101] quit
The configuration on Switch C and Switch E is similar to the configuration on Switch B.
3) Configure C-BSRs and C-RPs
# Configure Loopback 0 as a C-BSR and a C-RP on Switch B.
[SwitchB] pim
[SwitchB-pim] c-bsr loopback 0
[SwitchB-pim] c-rp loopback 0
[SwitchB-pim] quit
The configuration on Switch C and Switch E is similar to the configuration on Switch B.
4) Configure a static RPF peer
# Configure Switch C and Switch E as a static RPF peers of Switch B.
[SwitchB] ip ip-prefix list-df permit 192.168.0.0 16 greater-equal 16
less-equal 32
[SwitchB] msdp
[SwitchB-msdp] peer 192.168.3.1 connect-interface vlan-interface 102
8-25
Chapter 8 MSDP Configuration