H3C S5500-EI series Operation Manual page 1343

Operation Manual – VRRP
H3C S5500-EI Series Ethernet Switches
[SwitchB] vlan 2
[SwitchB-vlan2] port GigabitEthernet 1/0/5
[SwitchB-vlan2] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ipv6 address fe80::2 link-local
# Create a standby group 1 and set its virtual IP address to FE80::10.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
# Enable Switch B to send RA messages.
[SwitchB-Vlan-interface2] undo ipv6 nd ra halt
3) Verify the configuration
After the configuration, Host B can be pinged through on Host A. You can use the
display vrrp ipv6 command to verify the configuration.
# Display detailed information of standby group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
# Display detailed information of standby group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 110
: YES
: NONE
: FE80::10
: 0000-5e00-0201
: FE80::1
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 100
: YES
: NONE
: FE80::10
: FE80::1
1-31
Chapter 1 VRRP Configuration
Adver. Timer : 100
State : Master
Run Pri : 110
Delay Time : 0
Adver. Timer : 100
State : Backup
Run Pri : 100
Delay Time : 0