Snmp Logging Configuration Example - H3C S5500-EI series Operation Manual

Hide thumbs Also See for S5500-EI series:

Table of Contents

Operation Manual – SNMP-RMON

H3C S5500-EI Series Ethernet Switches

The configurations on the agent and the NMS must match.

1.7 SNMP Logging Configuration Example

I. Network requirements

NMS and Agent are connected through an Ethernet

The IP address of NMS is 1.1.1.2/24

The IP address of the VLAN interface on Agent is 1.1.1.1/24

Configure community name, access right and SNMP version on Agent

II. Network diagram

Figure 1-4 Network diagram for SNMP logging

III. Configuration procedure

The configurations for NMS and Agent are omitted.

# Enable logging display on the terminal (optional, enabled by default).

<Sysname> terminal monitor

<Sysname> terminal logging

# Enable the information center to output the system information with the severity of

informational to the Console port.

<Sysname> system-view

[Sysname] info-center source snmp channel console log level informational

# Enable SNMP logging on Agent to log the GET and SET operations of NMS.

[Sysname] snmp-agent log get-operation

[Sysname] snmp-agent log set-operation

Chapter 1 SNMP Configuration

Table of Contents