H3C S5500-EI series Operation Manual page 1340

Operation Manual – VRRP
H3C S5500-EI Series Ethernet Switches
[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.0
# Create a standby group 1 and set its virtual IP address to 202.38.160.111.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111
# Create a standby group 2 and set its virtual IP address to 202.38.160.112.
[SwitchB-Vlan-interface2] vrrp vrid 2 virtual-ip 202.38.160.112
# Configure the priority of Switch B in standby group 2 to 110.
[SwitchB-Vlan-interface2] vrrp vrid 2 priority 110
3) Verify the configuration
You can use the display vrrp command to verify the configuration.
# Display detailed information of the standby group on Switch A.
[SwitchA-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
# Display detailed information of the standby group on Switch B.
[SwitchB-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 110
: YES
: NONE
: 202.38.160.111
: 0000-5e00-0101
: 202.38.160.1
: Vlan-interface2
: 2
: UP
: 100
: YES
: NONE
: 202.38.160.112
: 202.38.160.2
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
1-28
Chapter 1 VRRP Configuration
Adver. Timer : 1
State : Master
Run Pri : 110
Delay Time : 0
Adver. Timer : 1
State : Backup
Run Pri : 100
Delay Time : 0
Adver. Timer : 1
State : Backup