Configuration Prerequisites; Configuration Procedure; Ignoring The Authorization Information From The Server - H3C S5500-EI series Operation Manual

Operation Manual – Port Security
H3C S5500-EI Series Ethernet Switches

1.7.1 Configuration Prerequisites

Enable port security
Set the maximum number of secure MAC addresses allowed on the port
Set the port security mode to autoLearn

1.7.2 Configuration Procedure

Follow these steps to configure a secure MAC address:
Enter system view
Configure
a secure
MAC
address
Note:
The configured secure MAC addresses are saved in the configuration file and will not
get lost when the port goes up or goes down. After you save the configuration file, the
secure MAC address saved in the configuration file are maintained even after the
device restarts.

1.8 Ignoring the Authorization Information from the Server

After an 802.1x user or MAC authenticated user passes RADIUS authentication, the
RADIUS server delivers the authorization information to the device. You can configure
a port to ignore the authorization information from the RADIUS server.
Follow these steps to configure a port to ignore the authorization information from the
RADIUS server:
Enter system view
Enter Ethernet port view
To do...
system-view
port-security mac-address
In system security mac-address interface
view interface-type interface-number
vlan vlan-id
interface interface-type
interface-number
In Ethernet
port view
port-security mac-address
security mac-address vlan vlan-id
To do...
system-view
interface interface-type
interface-number
Chapter 1 Port Security Configuration
Use the command...
Use the command...
1-10
Remarks
—
Required
Use either
approach
No secure MAC
address is
configured by
default.
Remarks
—
—