Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
1.12.2 DHCP Test Configuration Example
I. Network requirements
Use the NQA DHCP function to test the time necessary for Switch A to obtain an IP
address from the DHCP server Switch B.
II. Network diagram
Figure 1-4 Network diagram for DHCP
III. Configuration procedure
# Create a DHCP test group and configure related test parameters.
<SwitchA> system-view
[SwitchA] nqa entry admin test
[SwitchA-nqa-admin-test] type dhcp
[SwitchA-nqa-admin-test-dhcp] operation interface vlan-interface 2
[SwitchA-nqa-admin-test-dhcp] quit
# Enable the DHCP test.
[SwitchA] nqa schedule admin test start-time now lifetime forever
# Display results of one DHCP test.
[SwitchA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Send operation times: 1
Min/Max/Average round trip time: 624/624/624
Square-Sum of round trip time: 389376
Last succeeded probe time: 2007-03-14 17:47:29.3
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Receive response times: 1
1-24
Chapter 1 NQA Configuration