H3C S5500-EI series Operation Manual page 1373

Operation Manual – SSH
H3C S5500-EI Series Ethernet Switches
III. Configuration procedure
1) Configure the SSH server
# Generate RSA and DSA key pairs and enable SSH server.
<Switch> system-view
[Switch] public-key local create rsa
[Switch] public-key local create dsa
[Switch] ssh server enable
# Configure an IP address for VLAN interface 1. This address will serve as the
destination for the SSH client in connecting the server.
[Switch] interface vlan-interface 1
[Switch-Vlan-interface1] ip address 192.168.1.40 255.255.255.0
[Switch-Vlan-interface1] quit
# Set the authentication mode for the user interface to AAA.
[Switch] user-interface vty 0 4
[Switch-ui-vty0-4] authentication-mode scheme
# Enable the user interface to support SSH.
[Switch-ui-vty0-4] protocol inbound ssh
# Set the user command privilege level to 3.
[Switch-ui-vty0-4] user privilege level 3
[Switch-ui-vty0-4] quit
Note:
Before performing the following tasks, you must generate an RSA public key pair (using
the client software) on the client, save the key pair in a file named key.pub, and then
upload the file to the SSH server through FTP or TFTP. For details, refer to Configuring
the SSH Client.
# Import the client's public key from file "key.pub".
[Switch] public-key peer Switch001 import sshkey key.pub
# Specify the authentication type for user "client002" as publickey, and assign the public
key "Switch001" for the user.
[Switch]
publickey assign publickey Switch001
2) Configure the SSH client
# Generate an RSA key pair
Run PuTTYGen.exe, choose SSH2-(RSA) and click Generate.
ssh user client002 service-type stelnet
1-19
Chapter 1 SSH Configuration
authentication-type