Displaying Sflow; Sflow Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – sFlow
H3C S5500-EI Series Ethernet Switches
Caution:
The sFlow agent and sFlow collector must not have the same IP address.
Currently, you can specify at most two sFlow collectors on S5500-EI Series
Ethernet Switches.

1.3 Displaying sFlow

Display sFlow
configuration information

1.4 sFlow Configuration Example

I. Network requirements
Host A and Server are connected to Switch through GigabitEthernet 1/0/1 and
GigabitEthernet 1/0/2 respectively.
Host B works as an sFlow collector with IP address 3.3.3.2 and port number 6343,
and is connected to Switch through GigabitEthernet 1/0/3.
GigabitEthernet 1/0/3 belongs to VLAN 1, having an IP address of 3.3.3.1.
Run sFlow agent on Switch, and enable sFlow on GigabitEthernet 1/0/1 to monitor
traffic on this interface. Switch sends sFlow packets through GigabitEthernet 1/0/3 to
Host B, which then analyzes the sFlow packets and displays the results.
II. Network diagram
Figure 1-1 Network diagram for sFlow configuration
To do...
display sflow
Use the command...
1-3
Chapter 1 sFlow Configuration
Remarks
Available in any view