H3C S5500-EI series Operation Manual page 1440

Operation Manual – Port Security
H3C S5500-EI Series Ethernet Switches
Idle-cut = Disable
Self-service = Disable
Use the following command to view the port security configuration information:
<Switch> display port-security interface gigabitethernet 1/0/1
Equipment port-security is enabled
Trap is disabled
Disableport Timeout: 20s
OUI value:
Index is 1,
Index is 2,
Index is 3,
Index is 4,
Index is 5,
GigabitEthernet1/0/1 is link-up
Port mode is userLoginWithOUI
NeedToKnow mode is disabled
Intrusion Protection mode is NoAction
Max MAC address number is not configured
Stored MAC address number is 0
Authorization is permitted
After an 802.1x user gets online, you can see that the number of secure MAC
addresses stored is 1. You can also use the following command to view information
about 802.1x users:
<Switch> display dot1x interface gigabitethernet 1/0/1
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
Configuration: Transmit Period
EAD quick deploy configuration:
The maximum 802.1X user resource number is 1024 per slot
Total current used 802.1X resource number is 1
GigabitEthernet1/0/1
802.1X protocol is enabled
Handshake is enabled
OUI value is 123401
OUI value is 123402
OUI value is 123403
OUI value is 123404
OUI value is 123405
30 s,
Quiet Period 60 s,
Supp Timeout 30 s,
The maximal retransmitting times
EAD timeout: 30 m
is link-up
1-17
Chapter 1 Port Security Configuration
Handshake Period
Quiet Period Timer is disabled
Server Timeout
2
15 s
100 s