Configuring The Port Priority - H3C S5500-EI series Operation Manual

Operation Manual – QoS
H3C S5500-EI Series Ethernet Switches
5
6
7
II. Configuration procedure
# Enter system view.
<Sysname> system-view
# Enter dot1p-lp priority mapping table view.
[Sysname] qos map-table dot1p-lp
# Modify dot1p-lp priority mapping parameters.
[Sysname-maptbl-dot1p-lp] import 0 1 export 0
[Sysname-maptbl-dot1p-lp] import 2 3 export 1
[Sysname-maptbl-dot1p-lp] import 4 5 export 2
[Sysname-maptbl-dot1p-lp] import 6 7 export 3

5.3 Configuring the Port Priority

By default, if a port receives packets without 802.1q tags, the switch takes the priority of
the receiving port as the 802.1p precedence of the received packets, searches the
dot1p-lp/dp mapping table for the corresponding local precedence and drop
precedence according to the 802.1p precedence of the received packets, and then
marks the received packets with the corresponding local precedence and drop
precedence.
Port priority is in the range 0 to 7. You can set the port priority as required.
5.3.1 Configuration Prerequisites
The port priority of the port is determined.
5.3.2 Configuration Procedure
Follow these steps to configure port priority:
802.1p precedence Local precedence
2
3
3
5-4
Chapter 5 Priority Mapping