H3C S5500-EI series Operation Manual page 1067

Operation Manual – QoS
H3C S5500-EI Series Ethernet Switches
Remarking the service
provider network VLAN ID
for packets
Caution:
Follow these rules when configuring a behavior. Otherwise the corresponding QoS
policy cannot be applied successfully.
The action of creating an outer VLAN tag cannot be configured simultaneously with
any other action except the traffic filtering action or the action of setting 802.1p
precedence in the same traffic behavior. The action of creating an outer VLAN tag
must be applied to basic QinQ-enabled ports or port groups.
When the action of setting the service provider network VLAN ID is applied in the
inbound direction, any other action except the traffic filtering action or the action of
setting 802.1p precedence cannot be configured in the same traffic behavior.
When the action of mirroring traffic is applied in the outbound direction, any other
action cannot be configured in the same traffic behavior.
II. Configuration example
1) Network requirements
Configure a policy named test to associate the traffic behavior named test_behavior
with the class named test_class. Apply the policy to the inbound direction of
GigabitEthernet 1/0/1 port.
2) Configuration procedure
# Enter system view.
<Sysname> system-view
# Create a policy (This operation leads you to policy view).
[Sysname] qos policy test
[Sysname-qospolicy-test]
# Associate the traffic behavior named test_behavior with the class named test_class.
[Sysname-qospolicy-test] classifier test_class behavior test_behavior
[Sysname-qospolicy-test] quit
# Enter port view.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1]
Action
Supported
Chapter 3 QoS Policy Configuration
Inbound
3-9
Outbound
Supported