Configuring The Snmp Test - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Note:
The number of probes made in a UDP-jitter test depends on the probe count
command, while the number of probe packets sent in each probe depends on the
probe packet-number command.

1.6.6 Configuring the SNMP Test

The SNMP query test is used to test the time the NQA client takes to send an SNMP
query packet to the SNMP agent and then receive a response packet.
I. Configuration prerequisites
The SNMP agent function must be enabled on the device serving as an SNMP agent
before the SNMP test. For the configuration of SNMP agent, refer to SNMP
Configuration.
II. Configuring the SNMP test
Follow these steps to configure the SNMP test:
Enter system view
Enter NQA test group
view
Configure the test type as
SNMP and enter test type
view
Configure the destination
address for a test
operation
Specify the source port
number for a probe
request in a test operation
Configure the source IP
address of a probe
request in a test operation
To do...
system-view
nqa entry admin-name
operation-tag
type snmp
destination ip ip-address
source port port-number
source ip ip-address
Use the command...
1-14
Chapter 1 NQA Configuration
Remarks
—
—
Required
Required
By default, no destination
IP address is configured
for a test operation.
Optional
By default, no source port
number is specified.
Optional
By default, no source IP
address is specified.
The source IP address
must be that of an
interface on the device
and the interface must be
up. Otherwise, the test will
fail.