Setting Lldp Operating Mode; Configuring Lldpdu Tlvs - H3C S5500-EI series Operation Manual

Operation Manual – LLDP
H3C S5500-EI Series Ethernet Switches

1.3.2 Setting LLDP Operating Mode

Follow these steps to set LLDP operating mode:
Enter system view
Set the initialization delay
period
Enter
Ethernet
interface
view/port
group
view
Set the LLDP operating
mode

1.3.3 Configuring LLDPDU TLVs

Follow these steps to configure LLDPDU TLVs:
To do...
Enter system view
Set the TTL multiplier
Enter
Ethernet
interface
view/port
group
view
To do...
system-view
lldp timer reinit-delay
value
Enter
Ethernet
interface interface-type
interface interface-number
view
port-group
Enter port { aggregation agg-id |
group view manual
port-group-name }
lldp admin-status
{ disable | rx | tx | txrx }
Use the command...
system-view
lldp hold-multiplier value
Enter
Ethernet interface interface-type
interface interface-number
view
Enter
port-group { aggregation
port
agg-id | manual
group
port-group-name }
view
Use the command...
1-6
Chapter 1 LLDP Configuration
Remarks
—
Optional
2 seconds by default.
Either of the two is
required.
Configuration performed
in Ethernet interface view
applies to the current port
only; configuration
performed in port group
view applies to all the
ports in the corresponding
port group.
Optional
TxRx by default.
Remarks
—
Optional
4 by default.
Either of the two is
required.
Configuration performed
in Ethernet interface view
applies to the current port
only; configuration
performed in port group
view applies to all the
ports in the corresponding
port group.