H3C S5500-EI series Operation Manual page 1439

Operation Manual – Port Security
H3C S5500-EI Series Ethernet Switches
[Switch] port-security oui 1234-0100-1111 index 1
[Switch] port-security oui 1234-0200-1111 index 2
[Switch] port-security oui 1234-0300-1111 index 3
[Switch] port-security oui 1234-0400-1111 index 4
[Switch] port-security oui 1234-0500-1111 index 5
[Switch] interface gigabitethernet 1/0/1
# Set the port security mode to userLoginWithOUI.
[Switch-GigabitEthernet1/0/1] port-security port-mode userlogin-withoui
3) Verify the configuration
After completing the above configurations, you can use the following command to view
the configuration information of the RADIUS scheme named radsun:
<Switch> display radius scheme radsun
SchemeName
Index = 0
Primary Auth IP
Primary Acct IP
Second
Second
Auth Server Encryption Key = name
Acct Server Encryption Key = money
Accounting-On packet disable, send times = 5 , interval = 3s
Interval for timeout(second)
Retransmission times for timeout
Interval for realtime accounting(minute)
Retransmission times of realtime-accounting packet
Retransmission times of stop-accounting packet
Quiet-interval(min)
Username format
Data flow unit
Packet unit
Use the following command to view the configuration information of the ISP domain
named sun:
<Switch> display domain sun
Domain = sun
State = Active
Access-limit = 30
Accounting method = Required
Default authentication scheme
Default authorization scheme
Default accounting scheme
Domain User Template:
= radsun
= 192.168.1.1
= 192.168.1.2
Auth IP = 192.168.1.2
Acct IP = 192.168.1.1
Chapter 1 Port Security Configuration
Type = standard
Port = 1812
Port = 1813
Port = 1812
Port = 1813
: radius=radsun
: local
: local
1-16
State = active
State = active
State = active
State = active
= 5
= 5
= 15
= 5
= 500
= 5
= without-domain
= Byte
= one