H3C S5500-EI series Operation Manual page 1285

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Configure the test type as
ICMP-echo and enter test
type view
Configure the destination
address for a test
operation
Configure the size of
probe packets sent
Configure the string used
to fill a probe packet
Specify the IP address of
an interface as the source
IP address of an
ICMP-echo request
Configure the source IP
address of a probe
request
To do...
type icmp-echo
destination ip ip-address
data-size size
data-fill string
source interface
interface-type
interface-number
source ip ip-address
Use the command...
1-7
Chapter 1 NQA Configuration
Remarks
Required
Required
By default, no destination
IP address is configured
for a test operation.
Optional
100 bytes by default.
Optional
The string of fill characters
of a probe packet is the
string corresponding with
the ASCII code 00 to 09
by default.
Optional
By default, no interface
address is specified as
the source IP address of
ICMP probe requests.
If you use the source ip
command to configure the
source IP address of
ICMP-echo probe
requests, the source
interface command is
invalid.
The interface specified by
this command must be up.
Otherwise, the probe will
fail.
Optional
By default, no source IP
address is specified.
If no source IP address is
specified, but the source
interface is specified, the
IP address of the source
interface is taken as the
source IP address of
ICMP probe requests.
The source IP address
must be that of an
interface on the device
and the interface must be
up. Otherwise, the probe
will fail.