Configuring Multi-Domain Intersecting Ring Topology - H3C S5500-EI series Operation Manual

Operation Manual – RRPP
H3C S5500-EI Series Ethernet Switches
[Device C] rrpp enable
4) Perform the following configuration on Device D:
<Device D> system-view
[DeviceD] interface gigabitethernet 1/0/1
[DeviceD-GigabitEthernet1/0/1] link-delay 0
[DeviceD-GigabitEthernet1/0/1] quit
[DeviceD] interface gigabitethernet 1/0/2
[DeviceD-GigabitEthernet1/0/2] link-delay 0
[DeviceD-GigabitEthernet1/0/2] quit
[Device D] rrpp domain 1
[Device D-rrpp-domain1] control-vlan 4092
[Device D-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet
1/0/1 secondary-port gigabitethernet 1/0/2 level 0
[Device D-rrpp-domain1] ring 1 enable
[Device D-rrpp-domain1] quit
[Device D] rrpp enable
5) Perform the following configuration on Device E:
<Device E> system-view
[DeviceE] interface gigabitethernet 1/0/1
[DeviceE-GigabitEthernet1/0/1] link-delay 0
[DeviceE-GigabitEthernet1/0/1] quit
[DeviceE] interface gigabitethernet 1/0/2
[DeviceE-GigabitEthernet1/0/2] link-delay 0
[DeviceE-GigabitEthernet1/0/2] quit
[Device E] rrpp domain 1
[Device E-rrpp-domain1] control-vlan 4092
[Device E-rrpp-domain1] ring 2 node-mode master primary-port gigabitethernet
1/0/1 secondary-port gigabitethernet 1/0/2 level 1
[Device E-rrpp-domain1] ring 2 enable
[Device E-rrpp-domain1] quit
[Device E] rrpp enable
After the configuration, you can use the display command to view RRPP configuration
result.

1.8.3 Configuring Multi-Domain Intersecting Ring Topology

I. Networking requirements
Device A, Device B, Device C and Device D constitute RRPP domain 1, and
Device E, Device F, Device C and Device B constitute RRPP domain 2;
VLAN 4090 is the control VLAN of RRPP domain 1, and VLAN 4092 is the control
VLAN of RRPP domain 2;
Device A, Device B, Device C and Device D constitute primary ring 1;
1-24
Chapter 1 RRPP Configuration