H3C S5500-EI series Operation Manual page 1121

Operation Manual – Cluster Management
H3C S5500-EI Series Ethernet Switches
If the port of an access NM device (including FTP/TFTP server, NM host and log host)
does not allow the packets from the management VLAN to pass, the NM device cannot
manage the devices in a cluster through the management device. In this case, on the
management device, you need to configure the VLAN interface of the access NM
device (including FTP/TFTP server, NM host and log host) as the NM interface.
Follow these steps to configure the interaction for a cluster:
Enter system view
Enter cluster view
Configure the FTP server
shared by the cluster by
setting an IP address,
username and password
Configure the TFTP
server shared by the
member devices in the
cluster
Configure the log host
shared by the member
devices in the cluster
Configure the SNMP NM
host shared by the
member devices in the
cluster
Configure the NM
interface of the
management device
Caution:
For the configured log host to take effect, you must execute the info-center
loghost command in system view first. For more information about the info-center
loghost command, refer to Information Center Commands in the System Volume.
To isolate management protocol packets of a cluster from packets outside the
cluster, you are recommended to configure to prohibit packets from the
management VLAN from passing the ports that connect the management device
with the devices outside the cluster and configure the NM interface for the
management device.
To do...
system-view
cluster
ftp-server ip-address
[ user-name username
password { simple |
cipher } password ]
tftp-server ip-address
logging-host ip-address
snmp-host ip-address
[ community-string read
string1 write string2 ]
nm-interface
vlan-interface
vlan-interface-id
Chapter 1 Cluster Management Configuration
Use the command...
1-21
Remarks
—
—
Required
By default, no FTP server
is configured for a cluster.
Required
By default, no TFTP
server is configured for a
cluster.
Required
By default, no log host is
configured for a cluster.
Required
By default, no SNMP host
is configured.
Optional