Configuring An Interface To Dynamically Obtain An Ip Address Through Bootp - H3C S5500-EI series Operation Manual

Operation Manual – DHCP
H3C S5500-EI Series Ethernet Switches
6.2 Configuring an Interface to Dynamically Obtain an IP
Address Through BOOTP
Follow these steps to configure an interface to dynamically obtain an IP address:
Enter system view
Enter interface view
Configure an interface to
dynamically obtain IP
address through BOOTP
6.3 Displaying and Maintaining BOOTP Client Configuration
Display related
information on a BOOTP
client
6.4 BOOTP Client Configuration Example
I. Network requirement
Switch B's port belonging to VLAN 1 is connected to the LAN. VLAN-interface 1 obtains
an IP address from the DHCP server by using BOOTP.
II. Network diagram
See Figure
III. Configuration procedure
The following describes only the configuration on Switch B serving as a client.
# Configure VLAN-interface 1 to dynamically obtain an IP address from the DHCP
server.
<SwitchB> system-view
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] ip address bootp-alloc
To do...
system-view
interface interface-type
interface-number
ip address bootp-alloc
To do...
display bootp client
[ interface interface-type
interface-number ]
2-1.
Chapter 6 BOOTP Client Configuration
Use the command...
Use the command...
6-3
Remarks
—
—
Required
By default, an interface
does not use BOOTP to
obtain an IP address.
Remarks
Available in any view