Configuring The Nqa Server - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Configuring an NQA
Test Group
Configuring the Collaboration Function
Configuring Trap Delivery
Configuring Optional Parameters Common to an NQA
Test Group
Scheduling an NQA Test Group

1.3 Configuring the NQA Server

Before performing TCP, UDP-echo or UDP-jitter tests, you need to configure the NQA
server on the peer device. The NQA server makes a response to the request originated
by the NQA client by listening to the specified destination address and port number.
Follow these steps to configure the NQA server:
Enter system view
Enable the NQA server
Configure the UDP or
TCP listening function on
the NQA server
Task
Configuring the ICMP-echo
Test
Configuring the DHCP Test
Configuring the FTP Test
Configuring the HTTP Test
Configuring the UDP-jitter Test
Configuring the SNMP Test
Configuring the TCP Test
Configuring the UDP-echo Test
Configuring the DLSw Test
To do...
system-view
nqa server enable
nqa server { tcp-connect
| udp-echo } ip-address
port-number
Use the command...
1-5
Chapter 1 NQA Configuration
Remarks
Use any of the
approaches.
Optional
Optional
Optional
Required
Remarks
—
Required
Disabled by default.
Required
The IP address and port
number must be
consistent with those
configured on the NQA
client and must be
different from those of an
existing listening service.