H3C S5500-EI series Operation Manual page 1295

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
II. Configuring the UDP-echo test
Follow these steps to configure the UDP-echo test
Enter system view
Enter NQA test group
view
Configure the test type as
UDP-echo and enter test
type view
Configure the destination
address for a test
operation
Configure the destination
port
Configure the size of
probe packets sent
Configure the string of fill
characters of a probe
packet sent
Specify a source port
number for a probe
request in a test operation
To do...
system-view
nqa entry admin-name
operation-tag
type udp-echo
destination ip ip-address
destination port
port-number
data-size size
data-fill string
source port port-number
Use the command...
1-17
Chapter 1 NQA Configuration
Remarks
—
—
Required
Required
By default, no destination
IP address is configured
for a test operation.
The destination address
must be the IP address of
the listening service
configured on the NQA
server.
Required
By default, no destination
port number is configured
for a test operation.
The destination port
number must be the port
number of the listening
service configured on the
NQA server.
Optional
100 bytes by default.
Optional
The string of fill characters
of an ICMP probe packet
is the string
corresponding with the
ASCII code 00 to 09 by
default.
Optional
By default, no source port
number is specified.