H3C S5500-EI series Operation Manual page 1454

Operation Manual – LLDP
H3C S5500-EI Series Ethernet Switches
To do...
Enable LLDP TLV
sending for specific
types of LLDP TLVs
Specify the
management address
and specify to send
the management
address through
LLDPDUs
Use the command...
lldp tlv-enable { basic-tlv
{ all | port-description |
system-capability |
system-description |
system-name } | dot1-tlv
{ all | port-vlan-id |
protocol-vlan-id [ vlan-id ] |
vlan-name [ vlan-id ] } |
dot3-tlv { all |
link-aggregation |
mac-physic |
max-frame-size | power } |
med-tlv { all | capability |
location-id { civic-address
device-type country-code
{ ca-type ca-value }&<1-10> |
elin-address Tel-Number } |
network-policy |
power-over-ethernet |
inventory } }
lldp
management-address-tlv
[ ip-address ]
1-7
Chapter 1 LLDP Configuration
Remarks
Optional
By default, all types of
LLDP TLVs except
location identification TLV
are sent.
Optional
By default, the
management address is
sent through LLDPDUs,
and the management
address is the IP address
of the interface of the
VLAN with the least VLAN
ID among those permitted
on the port. If the IP
address of the VLAN
interface is not configured,
IP address 127.0.0.1 is
used as the management
address. Refer to VLAN
Configuration for
information about VLAN.