Ftp Test Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Failures due to other errors: 0

1.12.3 FTP Test Configuration Example

I. Network requirements
Use the NQA FTP function to test the connection with a specified FTP server and the
time necessary for Device A to upload a file to the FTP server. The login username is
admin, the login password is systemtest, and the file to be transferred to the FTP
server is config.txt.
II. Network diagram
Figure 1-5 Network diagram for FTP
III. Configuration procedure
# Create an FTP test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type ftp
[DeviceA-nqa-admin-test-ftp] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-ftp] source ip 10.1.1.1
[DeviceA-nqa-admin-test-ftp] operation put
[DeviceA-nqa-admin-test-ftp] username admin
[DeviceA-nqa-admin-test-ftp] password systemtest
[DeviceA-nqa-admin-test-ftp] filename config.txt
[DeviceA-nqa-admin-test-ftp] quit
# Enable the FTP test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of an FTP test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1
Min/Max/Average round trip time: 173/173/173
Square-Sum of round trip time: 29929
Last succeeded probe time: 2007-03-14 13:28:48.5
Extend results:
Receive response times: 1
1-25
Chapter 1 NQA Configuration