Configuring The Dlsw Test - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Configure the source IP
address of a probe
request in a test operation
Configure common
optional parameters

1.6.9 Configuring the DLSw Test

The DLSw test is used to test the response time of the DLSw device.
I. Configuration prerequisites
Enable the DLSw function on the peer device before DLSw test.
II. Configuring the DLSw test
Follow these steps to configure the DLSw test:
Enter system view
Enter NQA test group
view
Configure the test type as
DLSw and enter test type
view
Configure the destination
address for a test
operation
Configure the source IP
address of a probe
request in a test operation
To do...
source ip ip-address
Refer to
Optional Parameters
Common to an NQA Test
Group
To do...
system-view
nqa entry admin-name
operation-tag
type dlsw
destination ip ip-address
source ip ip-address
Use the command...
Configuring
Use the command...
1-18
Chapter 1 NQA Configuration
Remarks
Optional
By default, no source IP
address is specified.
The source IP address
must be that of an
interface on the device
and the interface must be
up. Otherwise, the test will
fail.
Optional
Remarks
—
—
Required
Required
By default, no destination
IP address is configured
for a test operation.
Optional
By default, no source IP
address is specified.
The source IP address
must be that of an
interface on the device
and the interface must be
up. Otherwise, the test will
fail.