Configuring Trap Delivery; Configuring Optional Parameters Common To An Nqa Test Group - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches

1.8 Configuring Trap Delivery

Traps can be sent to the network management server when test is completed, test fails
or probe fails.
I. Configuration prerequisites
Before configuring trap delivery, you need to configure the destination address of the
trap message with the snmp-agent target-host command, create an NQA test group,
and configure related parameters. For the introduction to the snmp-agent target-host
command, refer to SNMP Commands.
II. Configuring trap delivery
Follow these steps to configure trap delivery:
Enter system view
Enter NQA test group
view
Enter test type view of the
test group
Configure to send traps to
network management
server under specified
conditions
1.9 Configuring Optional Parameters Common to an NQA
Test Group
Optional parameters common to an NQA test group are valid only for tests in this test
group.
Unless otherwise specified, the following parameters are applicable to all test types and
they can be configured according to the actual conditions.
Follow these steps to configure optional parameters common to an NQA test group:
Enter system view
Enter NQA test group
view
To do...
system-view
nqa entry admin-name
operation-tag
type { dhcp | dlsw | ftp |
http | icmp-echo | snmp |
tcp | udp-echo |
udp-jitter }
reaction trap
{ probe-failure
consecutive-probe-failure
s | test-complete |
test-failure
cumulate-probe-failures }
To do... Use the command...
system-view
nqa entry admin-name
operation-tag
Use the command...
—
—
1-20
Chapter 1 NQA Configuration
Remarks
—
—
—
Optional
No traps are sent to the
network management
server by default.
Remarks