Operation Manual – RRPP
H3C S5500-EI Series Ethernet Switches
[Sysname-GigabitEthernet1/0/2] link-delay 0
[Sysname-GigabitEthernet1/0/2] quit
[Sysname] interface gigabitethernet 1/0/4
[Sysname-GigabitEthernet1/0/4] link-delay 0
[Sysname-GigabitEthernet1/0/4] quit
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 4092
[Sysname-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet
1/0/1 secondary-port gigabitethernet 1/0/2 level 0
[Sysname-rrpp-domain1] ring 2 node-mode edge common-port gigabitethernet
1/0/2 edge-port gigabitethernet 1/0/4
[Sysname-rrpp-domain1] ring 1 enable
[Sysname-rrpp-domain1] ring 2 enable
[Sysname-rrpp-domain1] quit
[Sysname] rrpp enable
1.6 Configuring Assistant Edge Node
1.6.1 Configuration Procedure
Follow these steps to configure assistant edge node:
Enter system view
Create an RRPP domain
and enter its view
Specify a control VLAN for
the RRPP domain
Specify the current device
as the transit node of the
primary ring, and specify
the primary port and the
secondary port
Specify the current device
as the assistant edge
node of the subring, and
specify a common port
and an edge port
Enable the primary ring
To do...
system-view
rrpp domain domain-id
control-vlan vlan-id
ring ring-id node-mode
transit [ primary-port
interface-type
interface-number ]
[ secondary-port
interface-type
interface-number ] level
level-value
ring ring-id node-mode
assistant-edge
[ common-port
interface-type
interface-number ]
[ edge-port interface-type
interface-number ]
ring ring-id enable
Use the command...
1-16
Chapter 1 RRPP Configuration
Remarks
—
Required
Required
Required
Required
Required
By default, the RRPP ring
is disabled.