H3C S5500-EI series Operation Manual page 1438

Operation Manual – Port Security
H3C S5500-EI Series Ethernet Switches
# Set the IP addresses of the primary authentication and accounting servers to
192.168.1.1 and 192.168.1.2 respectively.
[Switch-radius-radsun] primary authentication 192.168.1.1
[Switch-radius-radsun] primary accounting 192.168.1.2
# Set the IP addresses of the secondary authentication and accounting servers to
192.168.1.2 and 192.168.1.1 respectively.
[Switch-radius-radsun] secondary authentication 192.168.1.2
[Switch-radius-radsun] secondary accounting 192.168.1.1
# Set the encryption key for the switch to use when interacting with the authentication
server to name.
[Switch-radius-radsun] key authentication name
# Set the encryption key for the switch to use when interacting with the accounting
server to money.
[Switch-radius-radsun] key accounting money
# Set the RADIUS server response timeout time to five seconds and the maximum
number of RADIUS packet retransmission attempts to 5.
[Switch-radius-radsun] timer response-timeout 5
[Switch-radius-radsun] retry 5
# Set the interval at which the switch sends real-time accounting packets to the
RADIUS server to 15 minutes.
[Switch-radius-radsun] timer realtime-accounting 15
# Specify that the switch sends user names without domain names to the RADIUS
server.
[Switch-radius-radsun] user-name-format without-domain
[Switch-radius-radsun] quit
# Create an ISP domain named sun and enter its view.
[Switch] domain sun
# Configure the ISP domain to use RADIUS scheme radsun as its default RADIUS
scheme.
[Switch-isp-sun] authentication default radius-scheme radsun
# Allow the ISP domain to accommodate up to 30 users.
[Switch-isp-sun] access-limit enable 30
[Switch-isp-sun] quit
2) Configure port security
# Enable port security.
[Switch] port-security enable
# Add five OUI values.
Chapter 1 Port Security Configuration
1-15