H3C S5500-EI series Operation Manual page 1291

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Configure the destination
port for a test operation
Specify the source port
number for a request
Configure the size of a
probe packet sent
Configure the string of fill
characters of a probe
packet sent
Configure the number of
consecutive packets in a
UDP-jitter probe
Configure the interval for
sending consecutive
packets
Configure the time for
waiting for a response in a
UDP-jitter test
Configure the source IP
address of a probe
request in a test operation
Configure common
optional parameters
To do...
destination port
port-number
source port port-number
data-size size
data-fill string
probe packet-number
packet-number
probe packet-interval
packet-interval
probe packet-timeout
packet-timeout
source ip ip-address
Refer to
Optional Parameters
Common to an NQA Test
Group
Use the command...
Configuring
1-13
Chapter 1 NQA Configuration
Remarks
Required
By default, no destination
port number is configured
for a test operation.
The destination port must
be consistent with that of
the existing listening
service on the NQA
server.
Optional
By default, no source port
number is specified.
Optional
100 bytes by default.
Optional
The string of fill characters
of an ICMP probe packet
is the string
corresponding to the
ASCII code 00 to 09 by
default.
Optional
10 by default.
Optional
20 milliseconds by
default.
Optional
3000 milliseconds by
default.
Optional
By default, no source IP
address is specified.
The source IP address
must be that of an
interface on the device
and the interface must be
up. Otherwise, the test will
fail.
Optional