Disabling An Interface From Receiving Ntp Messages; Configuring The Maximum Number Of Dynamic Sessions Allowed; Configuring Access-Control Rights - H3C S5500-EI series Operation Manual

Operation Manual – NTP
H3C S5500-EI Series Ethernet Switches
Enter system view
Configure the interface used to
send NTP messages
Caution:
If you have specified an interface in the ntp-service unicast-server or ntp-service
unicast-peer command, this interface will be used for sending NTP messages.

1.4.2 Disabling an Interface from Receiving NTP Messages

Enter system view
Enter interface view
Disable the interface from
receiving NTP messages

1.4.3 Configuring the Maximum Number of Dynamic Sessions Allowed

Enter system view
Configure the maximum
number of dynamic
sessions allowed to be
established locally

1.5 Configuring Access-Control Rights

With the following command, you can configure the NTP service access-control right to
the local switch. There are four access-control rights, as follows:
To do...
To do...
system-view
interface interface-type
interface-number
ntp-service in-interface
disable
To do...
system-view
ntp-service
max-dynamic-sessions
number
Use the command...
system-view
ntp-service source-interface
interface-type interface-number
Use the command...
Use the command...
1-13
Chapter 1 NTP Configuration
Remarks
—
Required
Remarks
—
—
Required
An interface is enabled to
receive NTP messages by
default
Remarks
—
Required
100 by default