Poe Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – PoE
H3C S5500-EI Series Ethernet Switches

1.10 PoE Configuration Example

I. Network requirements
The device provides power supply for PDs through PoE interfaces.
GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 are connected to IP telephones.
GigabitEthernet 1/0/11 and GigabitEthernet 1/0/12 are connected to access point
(AP) devices.
The power priority of GigabitEthernet 1/0/2 is critical.
The power of the AP device connected to GigabitEthernet 1/0/11 does not exceed
9,000 milliwatts.
II. Network diagram
Figure 1-1 Network diagram for PoE
III. Configuration procedure
# Enable PoE on GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, GigabitEthernet 1/0/11,
and GigabitEthernet 1/0/12.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] poe enable
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] interface GigabitEthernet 1/0/2
[Sysname-GigabitEthernet1/0/2] poe enable
[Sysname-GigabitEthernet1/0/2] quit
[Sysname] interface GigabitEthernet 1/0/11
[Sysname-GigabitEthernet1/0/11] poe enable
[Sysname-GigabitEthernet1/0/11] quit
[Sysname] interface GigabitEthernet 1/0/12
[Sysname-GigabitEthernet1/0/12] poe enable
[Sysname-GigabitEthernet1/0/12] quit
GE1/0/1
GE1/0/11
GE1/0/2 GE1/0/12
1-9
Chapter 1 PoE Configuration