Displaying And Maintaining Rrpp; Rrpp Typical Configuration Examples; Configuring Single Ring Topology - H3C S5500-EI series Operation Manual

Operation Manual – RRPP
H3C S5500-EI Series Ethernet Switches
[Sysname-GigabitEthernet1/0/2] link-delay 0
[Sysname-GigabitEthernet1/0/2] quit
[Sysname] interface gigabitethernet 1/0/4
[Sysname-GigabitEthernet1/0/4] link-delay 0
[Sysname-GigabitEthernet1/0/4] quit
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 4092
[Sysname-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet
1/0/1 secondary-port gigabitethernet 1/0/2 level 0
[Sysname-rrpp-domain1]
gigabitethernet 1/0/2 edge-port gigabitethernet 1/0/4
[Sysname-rrpp-domain1] ring 1 enable
[Sysname-rrpp-domain1] ring 2 enable
[Sysname-rrpp-domain1] quit
[Sysname] rrpp enable

1.7 Displaying and Maintaining RRPP

Display brief information
about RRPP configuration
Display detailed
information about RRPP
configuration
Display RRPP statistics
Clear RRPP statistics

1.8 RRPP Typical Configuration Examples

This section covers these topics:

Configuring Single Ring Topology

Configuring Intersecting Ring Topology
1.8.1 Configuring Single Ring Topology
I. Networking requirements
Device A, Device B, Device C and Device D constitute RRPP domain 1;
Specify the control VLAN of RRPP domain 1 as VLAN 4092;
Device A, Device B, Device C and Device D constitute primary ring 1;
ring
To do...
display rrpp brief
display rrpp verbose domain
domain-id [ ring ring-id ]
display rrpp statistics domain
domain-id [ ring ring-id ]
reset rrpp statistics domain
domain-id [ ring ring-id ]
2 node-mode assistant-edge
Use the command...
1-18
Chapter 1 RRPP Configuration
common-port
Remarks
Available in
any view
Available in
user view