H3C S5500-EI series Operation Manual page 1307

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
II. Network diagram
Figure 1-8 Network diagram for SNMP test
III. Configuration procedure
1) Configurations on SNMP agent.
# Enable the SNMP agent service and set the SNMP version to all, the read community
to public, and the write community to private.
<DeviceB> system-view
[DeviceB] snmp-agent sys-info version all
[DeviceB] snmp-agent community read public
[DeviceB] snmp-agent community write private
2) Configurations on Device A.
# Create an SNMP query test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type snmp
[DeviceA-nqa-admin-test-snmp] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-snmp] quit
# Enable the SNMP query test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of an SNMP test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1
Min/Max/Average round trip time: 50/50/50
Square-Sum of round trip time: 2500
Last succeeded probe time: 2007-03-27 13:59:43.1
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Receive response times: 1
1-29
Chapter 1 NQA Configuration