System Debugging - H3C S5500-EI series Operation Manual

Operation Manual – System Maintaining and Debugging
H3C S5500-EI Series Ethernet Switches
View the routes from the
source to the destination
Note:
For a low-speed network, you are recommended to set a larger value for the timeout
timer (indicated by the -t parameter in the command) when configuring the ping
command.
Only the directly connected segment address can be pinged if the outgoing interface
is specified with the -i argument.

2.2.2 System Debugging

Enable the terminal
monitoring of system
information
Enable the terminal
display of debugging
information
Enable debugging for a
specified module
Display the enabled
debugging functions
To do...
tracert [ -a source-ip | -f
first-ttl | -m max-ttl | -p port
| -q packet-number | -w
timeout ] * remote-system
tracert ipv6 [ -f first-ttl |
-m max-ttl | -p port | -q
packet-number | -w
timeout ] * remote-system
To do...
terminal monitor
terminal debugging
debugging { all [ timeout
time ] | module-name
[ option ] }
display debugging
[ interface interface-type
interface-number ]
[ module-name ]
Chapter 2 System Maintaining and Debugging
Use the command...
Use the command...
2-4
Remarks
Optional
Used in IPv4 network
Available in any view
Optional
Used in IPv6 network
Available in any view
Remarks
Optional
The terminal monitoring
on the console is enabled
by default and that on the
monitoring terminal is
disabled by default.
Required
Disabled by default
Available in user view
Required
Disabled by default
Available in user view
Optional
Available in any view