Displaying And Maintaining Lldp - H3C S5500-EI series Operation Manual

Operation Manual – LLDP
H3C S5500-EI Series Ethernet Switches
Follow these steps to configure LLDP trap:
Enter system view
Enter
Ethernet
interface
view/port
group
view
Enable LLDP trap sending
Quit to system view
Set the interval to send
LLDP traps

1.5 Displaying and Maintaining LLDP

Display the global LLDP
information or the
information contained in
the LLDP TLVs to be sent
through a port
Display the information
contained in the LLDP
TLVs received through a
port
Display LLDP statistics
Display LLDP status of a
port
Display the types of the
LLDP TLVs that are
currently sent
To do...
system-view
Enter
Ethernet
interface interface-type
interface interface-number
view
port-group
Enter port { aggregation agg-id |
group view
manual
port-group-name }
lldp notification
remote-change enable
quit
lldp timer
notification-interval
value
To do...
display lldp local-information
[ global | interface interface-type
interface-number ]
display lldp
neighbor-information
[ interface interface-type
interface-number ] [ brief ]
display lldp statistics [ global |
interface interface-type
interface-number ]
display lldp status [ interface
interface-type interface-number ]
display lldp tlv-config
[ interface interface-type
interface-number ]
Use the command...
Use the command...
1-10
Chapter 1 LLDP Configuration
Remarks
—
Either of the two is
required.
Configuration performed
in Ethernet interface view
applies to the current port
only; configuration
performed in port group
view applies to all the
ports in the corresponding
port group.
Required
Disabled by default
—
Optional
5 seconds by default
Remarks
Available in any
view
Available in any
view
Available in any
view
Available in any
view
Available in any
view