Nqa Test Operation; Nqa Configuration Task List - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Figure 1-2 Relationship between the NQA client and NQA server
In most NQA tests, you only need to configure the NQA client; while in TCP, UDP-echo
and UDP-jitter tests, you must configure the NQA server.
You can create multiple TCP or UDP listening services on the NQA server, with each
listening service corresponding to a specified destination address and port number.
The IP address and port number specified for a listening service on the server must be
consistent with those on the client and must be different from those of an existing
listening service.

1.1.4 NQA Test Operation

After you create a test group and enter the test group view, you can configure related
test parameters. Test parameters vary with the test type. For details, see the
configuration procedure below.
To perform an NQA test successfully, make the following configurations on the NQA
client:
1) Enable the NQA client;
2) Create a test group and configure test parameters according to the test type;
3) Perform the NQA test through the nqa schedule command.
4) View test results using the display or debug commands.
For TCP, UDP-jitter or UDP-echo tests, you need to configure the NQA server on the
peer device.

1.2 NQA Configuration Task List

Complete these tasks to configure NQA.
Configuring the NQA Server
Enabling the NQA Client
Creating an NQA Test Group
Task
1-4
Chapter 1 NQA Configuration
Remarks
Required for TCP,
UDP-echo and UDP-jitter
tests
Optional
Required