H3C S5500-EI series Operation Manual page 1245

Operation Manual – Information Center
H3C S5500-EI Series Ethernet Switches
III. Configuration procedure
# Enable information center.
<Sysname> system-view
[Sysname] info-center enable
# Use channel console to output log information to the console (optional, console by
default).
[Sysname] info-center console channel console
# Disable the output of log, trap, and debugging information of all modules on the
channel console.
[Sysname] info-center source default channel console debug state off log state
off trap state off
Caution:
As the default system configurations for different channels are different, you need to
disable the output of log, trap, and debugging information of all modules on the
specified channel (console in this example) first and then configure the output rule as
needed so that unnecessary information will not be output.
# Configure the information output rule: allow log information of ARP and IP modules
with severity equal to or higher than informational to be output to the console.
[Sysname] info-center source arp channel console log level informational state
on
[Sysname] info-center source ip channel console log level informational state
on
[Sysname] quit
# Enable the display of log information on a monitor terminal.
<Sysname> terminal monitor
% Current terminal monitor is on
<Sysname> terminal logging
% Current terminal logging is on
After the above configuration takes effect, if the specified module generates log
information, the information center automatically sends the log information to the
console and displays it on the console.
Chapter 1 Information Center Configuration
1-20