H3C S5500-EI series Operation Manual page 1524

Operation Manual – Track
H3C S5500-EI Series Ethernet Switches
[SwitchB-Vlan-interface2] vrrp vrid 1 timer advertise 5
# Configure Switch B to work in preemptive mode, and set the preemption delay to five
seconds.
[SwitchB-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5
6) Verify the configuration
After configuration, ping Host B on Host A, and you can see that Host B is reachable.
Use the display vrrp command to view the configuration result.
# Display detailed information about VRRP group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Track Object
Virtual IP
Virtual MAC
Master IP
# Display detailed information about VRRP group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
The above output information indicates that in VRRP group 1, Switch A is the master
and Switch B is a backup. Packets from Host A to Host B are forwarded through Switch
A.
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 110
: YES
: SIMPLE TEXT
: 1
: 10.1.1.10
: 0000-5e00-0101
: 10.1.1.1
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 100
: YES
: SIMPLE TEXT
: 10.1.1.10
: 10.1.1.1
1-8
Chapter 1 Track Configuration
Adver. Timer : 5
State : Master
Run Pri : 110
Delay Time : 5
Key : hello
Pri Reduced : 0
Adver. Timer : 5
State : Backup
Run Pri : 100
Delay Time : 5
Key : hello