Operation Manual – System Maintaining and Debugging
H3C S5500-EI Series Ethernet Switches
Figure 2-1 The relationship between the protocol and screen debugging switch
Note:
Displaying debugging information on the terminal is the most commonly used way to
output debugging information. You can also output debugging information to other
directions. For details, refer to Information Center Configuration.
2.2 System Maintaining and Debugging
2.2.1 System Maintaining
Check whether a
specified IP address can
be reached
To do...
ping [ ip ] [ -a source-ip |
-c count | -f | -h ttl | -i
interface-type
interface-number | -m
interval | -n | -p pad | -q | -r
| -s packet-size | -t timeout
| -tos tos | -v ] *
remote-system
ping ipv6 [ -a source-ipv6
| -c count | -m interval | -s
packet-size | -t timeout ] *
remote-system [ -i
interface-type
interface-number ]
Chapter 2 System Maintaining and Debugging
Use the command...
2-3
Remarks
Optional
Used in IPv4 network
Available in any view
Optional
Used in IPv6 network
Available in any view