H3C S5500-EI series Operation Manual page 1110

Operation Manual – Cluster Management
H3C S5500-EI Series Ethernet Switches
Configure the interval to
send NDP packets
Caution:
The time for the receiving device to hold NDP packets cannot be shorter than the
interval to send NDP packets; otherwise, the NDP table may become instable.
1.3.3 Enabling NTDP Globally and for Specific Ports
Follow these steps to enable NTDP globally and for specific ports:
Enter system view
Enable NTDP globally
Enable NTDP for the port
To do...
ndp timer hello
hello-time
To do...
system-view
ntdp enable
interface interface-type
interface-number
ntdp enable
Chapter 1 Cluster Management Configuration
Use the command...
Use the command...
1-10
Remarks
Optional
60 seconds by default.
Remarks
—
Optional
Enabled by default
Optional
NTDP is enabled on all
ports by default.