Http Test Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0

1.12.4 HTTP Test Configuration Example

I. Network requirements
Use the HTTP function to test the connection with a specified HTTP server and the time
required to obtain data from the HTTP server.
II. Network diagram
Figure 1-6 Network diagram for the HTTP test
III. Configuration procedure
# Create an HTTP test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type http
[DeviceA-nqa-admin-test-http] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-http] operation get
[DeviceA-nqa-admin-test-http] url /index.htm
[DeviceA-nqa-admin-test-http] http-version v1.0
[DeviceA-nqa-admin-test-http] quit
# Enable the HTTP test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of an HTTP test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1
Min/Max/Average round trip time: 64/64/64
Receive response times: 1
1-26
Chapter 1 NQA Configuration