Dlsw Test Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1
Min/Max/Average round trip time: 25/25/25
Square-Sum of round trip time: 625
Last succeeded probe time: 2007-03-27 14:07:40.7
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0

1.12.9 DLSw Test Configuration Example

I. Network requirements
Use the NQA DLSw function to test the response time of the DLSw device.
II. Network diagram
Figure 1-11 Network diagram for the DLSw test
III. Configuration procedure
# Create a DLSw test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type dlsw
[DeviceA-nqa-admin-test-dlsw] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-dlsw] quit
# Enable the DLSw test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of one DLSw test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Receive response times: 1
1-32
Chapter 1 NQA Configuration