Performing Basic Lldp Configuration; Enabling Lldp - H3C S5500-EI series Operation Manual

Operation Manual – LLDP
H3C S5500-EI Series Ethernet Switches
Basic LLDP
configuration
Configuring LLDP Trap

1.3 Performing Basic LLDP Configuration

1.3.1 Enabling LLDP

Follow these steps to enable LLDP:
Enter system view
Enable LLDP globally
Enter
Ethernet
interface
view/port
group
view
Enable LLDP
Note:
To make LLDP take effect, you need to enable it both globally and on the related ports.
Task
Enabling LLDP
Setting LLDP Operating Mode
Configuring LLDPDU TLVs
Enable LLDP Polling
Configuring the Parameters Concerning
LLDPDU Sending
To do...
system-view
lldp enable
Enter
Ethernet interface interface-type
interface interface-number
view
port-group
Enter port { aggregation agg-id |
group view manual
port-group-name }
lldp enable
Use the command...
1-5
Chapter 1 LLDP Configuration
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Remarks
—
Required
The default global state of
LLDP varies with device
models.
Either of the two is
required.
Configuration performed
in Ethernet interface view
applies to the current port
only; configuration
performed in port group
view applies to all the
ports in the corresponding
port group.
Optional
By default, LLDP is
enabled on a port.