H3C S5500-EI series Operation Manual page 1289

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Configure the destination
address for a test
operation
Configure the source IP
address of a probe
request
Configure the operation
type
Configure the website that
an HTTP test visits
Configure the HTTP
version used in the HTTP
test
Configure common
optional parameters
Note:
The TCP port number for the HTTP server must be 80 in an HTTP test. Otherwise, the
test will fail.
To do...
destination ip ip-address
source ip ip-address
operation { get | post }
url url
http-version v1.0
Refer to
Optional Parameters
Common to an NQA Test
Group
Use the command...
Configuring
1-11
Chapter 1 NQA Configuration
Remarks
Required
By default, no destination
IP address is configured
for a test operation.
The destination IP
address for a test
operation is the IP
address of the HTTP
server.
Optional
By default, no source IP
address is specified.
The source IP address
must be that of an
interface on the device
and the interface must be
up. Otherwise, the test will
fail.
Optional
By default, the operation
type for the HTTP is get,
that is, obtaining data
from the HTTP server.
Required
Optional
By default, HTTP 1.0 is
used in an HTTP test.
Optional