Nqa Configuration Examples; Icmp-Echo Test Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches

1.12 NQA Configuration Examples

1.12.1 ICMP-echo Test Configuration Example

I. Network requirements
Use the NQA ICMP function to test whether the NQA client (Device A) can send
packets to the specified destination (Device B) and test the roundtrip time of packets.
II. Network diagram
Figure 1-3 Network diagram for the ICMP-echo test
III. Configuration procedure
# Create an ICMP-echo test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type icmp-echo
[DeviceA-nqa-admin-test-icmp-echo] destination ip 10.2.2.2
# Configure optional parameters.
[DeviceA-nqa-admin-test-icmp-echo] probe count 10
[DeviceA-nqa-admin-test-icmp-echo] probe timeout 500
[DeviceA-nqa-admin-test-icmp-echo] quit
# Enable the ICMP-echo test operation.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of an ICMP-echo test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 10
Min/Max/Average round trip time: 0/16/1
Square-Sum of round trip time: 256
Last succeeded probe time: 2007-03-14 17:21:07.8
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Receive response times: 10
1-23
Chapter 1 NQA Configuration